Problems With Rapid Splitter Production

التعليقات · 34 الآراء

Generally, when users imagine the manufacturing process of Log Splitter , they will feel that the design method of Log Splitter is relatively simple.

 

Generally, when users imagine the manufacturing process of Log Splitter , they will feel that the design method of Log Splitter is relatively simple. It can be processed into wood chips by putting materials into the machine. In fact, it is not so easy. Log Splitter is in the production process. Problems will accompany the emergence of problems, which cannot be avoided. No manufacturer can pack a ticket and say that there are no technical problems in production. Below we will answer two technical problems in detail:
  1. Log Splitter is the main reason for the feed roller jam, which is caused by a large number of forced feeding, horizontal feeding and thick wood (thickness greater than 12cm). Reasonably control the feed volume, and it is strictly forbidden to directly enter the machine with thick materials and large bundles of materials larger than 12cm. The raw materials are fed in the length direction and horizontally. If the raw materials are stuck in the feeding mechanism, only a wooden stick can be used to poke down between the upper drum and the sparse plate of the drum. Do not use iron to poke, so as not to fall into A serious accident occurred inside the machine.

2. The Log Splitter fan pressure decreases, the pump head speed decreases, its power supply voltage is low or the motor fails, the pipe network resistance increases, and the pipe network resistance is increased; the working state will change, adjust the working state; the motor rotates in the reverse direction, and the motor restarts wiring. The vibration of the machine is increased: bearing damage-replace the bearing, the fan impeller is unbalanced-remove foreign matter in the impeller or adjust the dynamic and static balance, the main shaft is deformed-replace the main shaft or pump head, the working state enters the end vibration zone-adjust the working state to avoid end vibration Zone, the air inlet and outlet filters are blocked-clean the filter. The flow rate of the fan is reduced: the inlet and outlet air filters are blocked-the filter is cleaned, the speed of the pump head is reduced-the power supply voltage is low or the motor is faulty, the resistance of the pipe network is increased-the resistance of the pipe network is reduced, the working state is increased-the working state is adjusted, and its motor Reverse direction-rewire the motor.
  Of course, experienced operators will do the relevant work before the Rapid Splitter starts production, and minimize the damage to the machine caused by the problem. When we encounter the above problems, we need to use skills and means to deal with them reasonably. The solution should be based on the actual situation or make appropriate adjustments. Do not operate the machine casually, which will affect the production quality of the machine.

 

التعليقات